Baytech MMP units controller Reset Procedures User Manual download pdf

ModularControllerResetProcedure



1),Removethe(5)screwfromthe

faceplate,RedArrows

2),UseEXTREMECAUTION:if

powerisappliedtounit,Pull

controllerouttorevealthe

connector,

RedArrow.

Pressthesmalltabincenterof

connectortoreleasethe

connectorfromthecircuitboard.

RedArrow

ProductionControllerresetsteps:ThisstepwillNOTaffectthestateoftheoutlets.

1. Use a paper clip or similar object, Press and hold a micro-switch in the hole next to the (SEL) button

under the LCD screen or between 2

& 3

LED (BLUE Arrow) disconnect the cable to the module for

5 seconds, (RED Arrow)

2. Continue to press micro-switch, connect cable to module, wait 10 seconds and release switch.

3. Serial in to the module. If it appears the controller did not reset, still contains old data, perform reset

again but increase the disconnect time to 10 seconds and wait time to 15 seconds.

Summary of Contents

Page 1

ModularControllerResetProcedure1),Removethe(5)screwfromthefaceplate,RedArrows2),UseEX

Related models: MRP units controller Reset Procedures | MSP units controller Reset Procedures |

Comments to this Manuals

No comments

Baytech MMP units controller Reset Procedures User Manual

Browse online or download User Manual for Computer hardware Baytech MMP units controller Reset Procedures. BayTech MMP units controller Reset Procedures User Manual

Summary of Contents

Related models: MRP units controller Reset Procedures | MSP units controller Reset Procedures |

Comments to this Manuals